Estimation of Inter-Layer Deposition Delay for Improved FDM Part Quality using Thermal Analysis
Keywords:
FDM, fused filament fabrication, finite element analysis, FEAAbstract
Fused deposition modeling (FDM) is widely used in additive manufacturing; however, part quality is significantly influenced by thermal history during layer-wise deposition. In particular, improper control of inter-layer deposition timing can lead to defects such as warping, residual stresses, and weak inter-layer bonding.
Although several studies have investigated thermal behavior in FDM, limited attention has been given to translating thermal analysis into practical process guidelines. In this study, a transient thermal model based on the element birth–death technique is developed using finite element analysis to simulate the sequential deposition of an ABS filament.
The model captures the temperature evolution of the deposited layer and its cooling behavior under convective boundary conditions. Based on the obtained temperature profile, a thermal stabilization time is defined and used to estimate the appropriate delay between successive layer depositions.
The results indicate that the deposited filament reaches near-ambient thermal conditions within approximately 20 seconds for the selected process parameters. This estimated delay provides a simple and practical guideline for improving inter-layer bonding and reducing thermally induced defects.
The proposed approach enables the conversion of thermal simulation results into actionable process planning inputs and can be integrated with slicing strategies for enhanced FDM part quality.